Solvera Pro Polycarbonate Support Angle
Sold exclusively through Polycarbonate Store Manufactured by renowned greenhouse experts, BC Greenhouse Builders
Couldn't load pickup availability
Additional Support for Polycarbonate Panels
Solvera Pro Polycarbonate Support Angles provide additional support beneath polycarbonate panels in roof and wall applications where panel spans exceed 24" or additional load support is desired.
Installed between Solvera Pro rafters and fastened directly to wood purlins or cross members, Support Angles help reduce panel deflection between rafters and provide added support across the glazing span.
Designed for Solvera Pro Installations
Support Angles are intended for use with polycarbonate glazing installed within the Solvera Pro Glazing System.
Available in White, Brown, and Black to match Solvera Pro Interior Rafters and Exterior End Rafters.
Cut to Fit Your Project
Support Angles may be cut to fit the spacing between rafters as needed.
Installation is straightforward:
- Measure the distance between Solvera Pro rafters.
- Cut the Support Angle to the required length if necessary.
- Using a 3/16" drill bit, drill a hole approximately 3" from each end.
- Fasten the Support Angle to the wood purlin or cross member using appropriate fasteners.
Multiple Support Angles may be used depending on panel length, rafter spacing, snow loads, and project requirements.